In this example we look at how to connect an IR Reciever. Generally, they require Vcc(5v) but I found this to work well with 3v3, GND and there is a data out which you connect to your Arduino. Here is a typical IR showing the pinout. ESP8266 WeMos D1 Mini Wireless Development Module. Free word searches online.
NeoPixels work between 3 and 7V, but the Wemos D1 Mini uses 3.3V logic for the GPIO, so matching the voltage to the logic is the best option. GND (G) on the Wemos D1 Mini connects to GND on theIn plain English, this means, "If you've uncommented either the #define USE_NODE_MCU_BOARD or #define USE_WEMOS_D1_MINI lines of code in the first tab of the sketch, then the following settings will be used for the physical button and LED". For example when you are using Ethernet shield, or work with hardware that connects to thesure - but checking the status of 2 pins takes only a few micro-seconds --> that won't kill your performance even if it's just a WeMos (compared to wifi latency and other operations) I'm sure you check in the main loop() the value of your counter --> so you do execute a test anyway each time you run the loop. ESP8266 Simple WiFi Example Project How to Test the ESP8266 WiFi Connection Conclusion Article Updates Prerequisite You will of course need a Wemos D1 Mini board, USB cable and a Mac/Linux/Windows machine to connect it to. Experience with Arduino is advantageous but not essential. Flash MicroPython firmware ¶. The boards were already flashed micropython firmware. If they lost firmware or you need lastest firmware, you can flash MicroPython firmware by yourself.
If you're looking for a great way to get started with the ESP32, the Wemos/LOLIN S2 mini is an excellent option. It comes in a form factor compatible with the ESP8266-based Wemos/LOLIN D1 mini, and the S2 mini can thus work with D2 mini shields. Ground, Vbus, and 3V3 pins are in the same place, though the IO pin numbering is different, so any swaps would certainly require a bit of
6Ozc.